Leica Geosystems GPS System 500 - Getting Started with Static and Kinematic Surveys User Manual

Page 40

Static and Kinematic Surveys-2.0.0en

Kinematic and Stop & Go surveying

6
7
8
9

3
3
9
3
4

Carrying out Kinematic and Stop & Go measurements, contd.

Press F1 CONT to proceed.

Step 3:

Taking kinematic and Stop & Go

measurements

After F1 CONT has been pressed the

survey panel appears:

Start with a static point measure-

ment. Measure a point for a few

minutes. Make sure you keep the

antenna steady:

Use a tripod on the starting point

Use supporting legs (quickstand)

in case the GPS antenna is

mounted on a rangepole

Hold the rangepole against a

fencepole or another stable object

Take the measurements of the

starting point by pressing F1 OCUPY

to start logging static observations,

followed by pressing F1 STOP after a

few minutes and F1 STORE to store

the point related information like

Point Id and Antenna Height.

Select a job of your choice.

Select the antenna setup you use,

most likely AT502 Pole (or AT501

Pole in case a SR510 sensor is

used):