Belt Drives CC-140 - Manual (Page 9)

FIGURE #15
30. Install new included retaining ring onto clutch hub at bearing. SEE FIG.#16
FIGURE #16
31. Clean and inspect transmission mainshaft, inner and outer primary covers for any old gasket
material or foreign debris and old oil, remove any old loctite ETC.
32. Apply RED LOCTITE to the splines of the mainshaft, do not over apply, the loctite will move inward
toward the mainshaft bearing, you do not want to get loctite in the bearing when you slide on the
hub and basket. SEE FIG.#17