Belt Drives CC-140 - Manual (Page 6)

20. Using some sort of paint pen or marker, make a mark on the front sprocket and primary chain this
will allow you to reinstall the primary chain in the correct direction, over time they wear in to each
other.
21. Remove front sprocket , primary chain and rear clutch assembly all together, this is a little tough
do to the stator rotor and magnets are attached to the front sprocket, it gets easier the further the
stator rotor gets from the engine / stator, magnetic pull. SEE FIG.#10
FIGURE #10
22. Separate the clutch basket from the other primary drive components; remove old clutch plates
from clutch basket. SEE FIG.#11
FIGURE #11
23. Time to separate the clutch hub from the clutch basket, you will need a 10-12 ton press for this.