Belt Drives TFCH-180 - Manual

BELT DRIVES LTD.
PART#'s EV-180 & TFCH-180
CLUTCH HUB REMOVAL AND INSTALLATION INSTRUCTIONS
THE USE OF RED THREAD LOCKER IS CRITICAL DURING INSTALLATION OF
CLUTCH HUB AND BASKET ASSEMBLIES ONTO SPLINED TRANSMISSION
MAINSHAFTS
Once you have removed the Pressure Plate , Clutch Pack, Hub Nut, Then the Hub and Basket assembly
you will need to perform the following. You Must use a press of some sort to perform these steps. Read the
complete instructions first.
Reference Note* Clutch hub is the smaller center component that rides on the mainshaft. The clutch Basket is the
larger component that the belt rides on. Hub and basket are connected by a hub bearing, Hub bearing is pressed into
basket and then hub is pressed into hub bearing
HUB REMOVAL FROM BASKET
1. Support the basket from the inside around the outside of clutch hub using a 4.500 I.D. by 4.00 tall, round piece of
material.
2. Remove the clutch hub retaining ring.
3. Using another solid round 1.400 O.D. by 3.00 tall material or object, place it on top of the tail shaft of the hub
and press the hub out of the hub / basket bearing.
*Note: Failure to support the inside of the clutch basket can / will damage the basket, Do not support the clutch
basket by the ring gear.