Belt Drives EVB-2S - Manual

1
INSTALLATION FOR BOLT IN BELT DRIVES (1986-UP MODELS)
(Kit Numbers: EVB-1T, EVB-1S, EVB-1SL, EVB-2T, EVB-2S)
Be sure to read the Warranty, Introduction, belt tracking and starter gear problems, alignment procedure
and disconnect battery.
1. Remove springs, shoulder bolts and clutch plates from clutch basket. This makes installation
easier.
2. Install front and rear pulleys and check for clearance. At this time you should determine if the
front pulley will need shimming or not depending on how the pulleys align with each other.
Remove pulleys and make any modifications if necessary. (Fig.1)
3. Grease the support bearing and install seal included with kit OR remove inner primary and install
sealed inner primary bearing (see Fig. 4) also supplied with kit. (See note below)
NOTE
: You must remove the mainshaft inner bearing race from the transmission mainshaft. This
is a sleeve type race that is pressed onto the mainshaft.
Fig.1- Install pulleys and check for fit; some clearance may be
necessary. Also, check for alignment to determine if shimming may
be necessary behind front pulley.
Fig.2- On early FXR’s, you may have to grind bottom of
starter fork, aluminum fork only. Fig. 3