Belt Drives DPP-200 - Manual

DPP-200 INSTALLATION INSTRUCTIONS
This kit is for installation on Belt Drives Ltd. Belt drive clutch hubs, except Top Fuel
Kit includes:
1. DPP-200 Pressure Plate.
1. DES-200 Diaphragm spring "copper in color".
1. DCS-100 Spring collar
4. ESB-1000 1" shoulder bolts.
4. 3/8" AN washers
1. Remove old pressure plate assembly.
2. Apply blue thread locker to a (4) hole pattern in the BDL clutch hub matching that of the (4)
hole pattern of the DPP-200.
3. Install supplied clutch adjusting screw with (2) O-rings, into pressure plate from the backside
so as not to damage O-rings, Loosely install jam nut onto threads of adjusting screw.