Belt Drives CC-140 - Manual (Page 14)

45. You may apply blue loctite to the (4) holes in the clutch hub matching the pattern of the pressure
plate(4) holes, insert the (4) pressure plate bolts through the spring retainer, spring and pressure
plate, then while applying light pressure from the front, hold the pressure plate from the back,
install pressure plate assembly onto the clutch hub, pay attention to the (42) ball bearings that they
do not fall out of their pockets under the spring, have a pan under the clutch area to catch any
bearings . SEE FIG.#25
FIGURE #25
46. Tighten the (4) bolts in an even pattern. Torque to 10-12 FT.LBS.
FIGURE #26
47. Install a new primary cover gasket, and reinstall outer primary cover, Note * you will need to
manually lift up on primary chain to clear adjuster shoe during installation. SEE FIG.#26