Cabletron Systems SMARTSWITCH ROUTER 9032578-05 - Manual (Page 91)

SmartSwitch Router User Reference Manual 65
Chapter 6: Packet-over-SONET Configuration Guide
Bridging and Routing Traffic Over a PoS Link
The following example shows how to configure a VLAN ‘v1’ that includes the PoS ports
on two connected SSRs, router A and router B. Bridged or routed traffic is transmitted
over the PoS link.
The following is the configuration for router A:
The following is the configuration for router B:
Router
A
Router
B
so.7.1 so.6.1
int1
1.1.1.1/8
2.1.1.1/8 peer 2.1.1.2 int1
1.1.1.2/8
2.1.1.2/8 peer 2.1.1.1
port set so.7.1 mtu 65535
stp enable port so.7.1
vlan create v1 port-based id 10
vlan add ports so.7.1 to v1
interface create ip int1 address-netmask 1.1.1.1/8 vlan v1
interface add ip int1 address-netmask 2.1.1.1/8 peer-address 2.1.1.2
port set so.6.1 mtu 65535
stp enable port so.6.1
vlan create v1 port-based id 10
vlan add ports so.6.1 to v1
interface create ip int1 address-netmask 1.1.1.2/8 vlan v1
interface add ip int1 address-netmask 2.1.1.2/8 peer-address 2.1.1.1