Cabletron Systems SMARTSWITCH ROUTER 9032578-05 - Manual (Page 74)

Displaying ATM Port Information
48 SmartSwitch Router User Reference Manual
Displaying ATM Port Information
There are a variety of ATM statistics that can be accessed through the command line
interface. The atm show commands can only be used in Enable mode.
To display information about the VPL configurations on an ATM port:
The following is an example of the information that is displayed with the command listed
above:
The following is a description of the display fields:
• Virtual Path Identifier Identifies a particular VP.
• Administrative Status Shows whether the VP is a viable network
element.
Up
indicates a viable network element.
Down indicates a non-viable network element.
• Operational Status Shows whether the VP is passing traffic.
Up
indicates traffic.
Down indicates no traffic.
• Last State Change Shows the last time the VP went up or down.
Time is in seconds relative to system bootup.
• Service Definition Shows the name of the defined service and its
traffic parameters
Displays the VPL configurations
on an ATM port. atm show vpl port | all-ports
ssr(atm-show)# vpl port at.9.1
VPL Table Contents for Slot 9, Port 1:
Virtual Path Identifier: 1
Administrative Status: Up
Operational Status: Up
Last State Change: 1581
Service Definition: ubr-default
Service Class: UBR
Peak Bit Rate: Best Effort
Sustained Bit Rate: 0 Kbits/sec (0 cps)
Maximum Burst Size: 0 cells
Encapsulation Type: Routed LLC
F5-OAM: Requests & Responses