Cabletron Systems SMARTSWITCH ROUTER 9032578-05 - Manual (Page 129)

SmartSwitch Router User Reference Manual 103
Chapter 9: VRRP Configuration Guide
To display VRRP statistics for virtual router 100 on interface int1:
To display VRRP information, enter the following commands in Enable mode.
VRRP Configuration Notes
• The Master router sends keep-alive advertisements. The frequency of these keep-alive
advertisements is determined by setting the Advertisement interval parameter. The
default value is 1 second.
• If a Backup router doesn’t receive a keep-alive advertisement from the current Master
within a certain period of time, it will transition to the Master state and start sending
advertisements itself. The amount of time that a Backup router will wait before it
becomes the new Master is based on the following equation:
Master-down-interval = (3 * advertisement-interval) + skew-time
ssr# ip-redundancy show vrrp 1 interface int1 verbose
VRRP Virtual Router 100 - Interface int1
------------------------------------------
Uptime 0 days, 0 hours, 0 minutes, 17 seconds.
State Backup
Priority 100 (default value)
Virtual MAC address 00005E:000164
Advertise Interval 1 sec(s) (default value)
Preempt Mode Enabled (default value)
Authentication None (default value)
Primary Address 10.8.0.2
Associated Addresses 10.8.0.1
100.0.0.1
Stats:
Number of transitions to master state 2
VRRP advertisements rcvd 0
VRRP packets sent with 0 priority 1
VRRP packets rcvd with 0 priority 0
VRRP packets rcvd with IP-address list mismatch 0
VRRP packets rcvd with auth-type mismatch 0
VRRP packets rcvd with checksum error 0
VRRP packets rcvd with invalid version 0
VRRP packets rcvd with invalid VR-Id 0
VRRP packets rcvd with invalid adv-interval 0
VRRP packets rcvd with invalid TTL 0
VRRP packets rcvd with invalid 'type' field 0
VRRP packets rcvd with invalid auth-type 0
VRRP packets rcvd with invalid auth-key 0
Display information about all
virtual routers. ip-redundancy show vrrp