Cabletron Systems SMARTSWITCH ROUTER 9032578-05 - Manual (Page 32)

Chapter 1: Introduction
6 SmartSwitch Router User Reference Manual
you are. For example, if you are at the User mode prompt, enter a question mark (?) as
shown in the following example to list the commands available in User mode:
You can also type the ? character while entering in a command line to see a description of
the parameters or options that you can enter. Once the help information is displayed, the
command line is redisplayed as before but without the ? character. The following is an
example of invoking help while entering a command:
If you enter enough characters of a command keyword to uniquely identify it and press
the space bar, the CLI attempts to complete the command. If you do not enter enough
characters or you enter the wrong characters, CLI cannot complete the command. For
example, if you enter the following in Enable mode and press the spacebar as indicated:
CLI completes the command as follows:
If you are entering several commands for the same subsystem, you can enter the
subsystem name from CLI. Then, execute individual commands for the subsystem
ssr> ?
aging
- Show L2 and L3 Aging information
cli - Modify the command line interface behavior
dvmrp - Show DVMRP related parameters
enable - Enable privileged user mode
exit - Exit current mode
file - File manipulation commands
help - Describe online help facility
igmp - Show IGMP related parameters
ip-redundancy - Show IP Redundancy information (VRRP)
ipx - Show IPX related parameters
l2-tables - Show L2 Tables information
logout - Log off the system
multicast - Configure Multicast related parameters
ping - Ping utility
pvst - Show Per Vlan Spanning Tree Protocol (PVST)
parameters
sfs
- Show SecureFast Switching (SFS) parameters
statistics - Show or clear SSR statistics
stp - Show STP status
telnet - Telnet utility
traceroute - Traceroute utility
vlan - Show VLAN-related parameters
ssr(config)# load-balance create ?
group-name - Name of this Load Balanced group of servers
vip-range-name - Name of this Virtual IP range
ssr(config)# load-balance create
ssr# system show e[space]
ssr# system show environmental