Cabletron Systems SMARTSWITCH ROUTER 9032578-05 - Manual (Page 139)

SmartSwitch Router User Reference Manual 113
Chapter 11: OSPF Configuration Guide
• Add IP interfaces to OSPF areas.
• Configure OSPF interface parameters, if necessary.
• Add IP networks to OSPF areas.
• Create virtual links, if necessary.
Enabling OSPF
OSPF is disabled by default on the SSR.
To enable or disable OSPF, enter one of the following commands in Configure mode.
Configuring OSPF Interface Parameters
You can configure the OSPF interface parameters shown in the table below.
Enable OSPF. ospf start
Disable OSPF. ospf stop
Table 6. OSPF Interface Parameters
OSPF Parameter Default Value
Interface OSPF State (Enable/Disable) Enable (except for virtual links)
Cost See “Default Cost of an OSPF Interface”
below.
No multicast Default is using multicast mechanism.
Retransmit interval 5 seconds
Transit delay 1 second
Priority 1
Hello interval 10 seconds (broadcast), 30 (non broadcast)
Router dead interval 4 times the hello interval
Poll Interval 120 seconds
Key chain N/A
Authentication Method None