WEATHER GUARD Model 236-3-01 Quick Clamp Rack, Full-Size, Curb Side - Manual (Page 8)

If you have any questions, please give us a call. Call Toll Free 1-800-456-7865
WEATHER GUARD® products are protected by one or more of the following patents or trademarks:
U.S. - 4618083, 5829654, 842268, 1661625, 1663369, 1750034, 2228051, 2362167; Canada - 1235100, 282725; U.K. - 1400720;
N.Z. - 296049; Aus. - 761964; other patents and trademarks pending.
KNAACK MANUFACTURING COMPANY
420 E. TERRA COTTA AVENUE - CRYSTAL LAKE, ILLINOIS, USA 60014 - 815-459-6020
©2004 Knaack Manufacturing Company
- NOTICE -
Any modification or unintended use of this product shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or
unintended use of this product.
WEATHER GUARD® PRODUCT
REFINISHING PROCEDURES
All WEATHER GUARD® products are
finished with a polyester powder coating, and it
is important to follow these procedures to get
proper adhesion. As Knaack Manufacturing Co.
cannot control the finishing of the products, the
warranty for WEATHER GUARD® products on
paint is not applicable on refinished products.
1. Sand the surface to be painted with 180-200
grit sand paper to rough up the surface. This
should be followed by wet sanding with a 400 grit
wet or dry paper.
2. Wipe down the sanded surface with ketone
based thinner. This removes the dust and
softens the powder coating for better paint
adhesion.
3. Wipe sanded area with a tack rag to remove
loose dust and particles before painting.
NOTE: Do not use a lacquer over the
powdered coating.