MK Diamond MK-2000 Gas Saws - Manual (Page 42)

42
MK-2000 GAS SAW TROUBLESHOOTING
MOVABLE CUTTING TABLE DOES NOT MOVE CORRECTLY
(A)
Check that the Guide Rails are
clean and clean if dirty.
(B)
Check the Movable Cutting
table Roller Wheels and re-
place if necessary.
(A)
Verify Water Pump drive end is in the
operating position - if in operating
position go to Step B.
COOLING FLOW
(B)
Check Cooling Flow Control
Valve is open.
(C)
Loosen hose clamp and remove
transfer tube from control valve on
Blade Guard.
(D)
Verify blade correct for material
being used.