MK Diamond MK-2000 Gas Saws - Manual (Page 25)

25
this method is preferred when cutting small objects.
Skip step D, if cutting dry.
(H)
Move the Throttle Lever to
lower blade speed.
(G)
Continue lowering the
Cutting Head until the
cut is complete.
MK-2000 GAS SAW OPERATION
CUTTING WITH THE CUTTING HEAD LOCKED DOWN
NOTE:
(I)
Raise Cutting Head once cut
is complete and turn OFF saw.
Refer to Engine Manual for
complete shutdown procedures.
DO NOT FORCE TOOL, it will do the job better and safer at the rate for which
it was designed.
CAUTION
(A)
Set the adjustable Cutting
Guide.
(B)
Position the masonry piece.
(C)
Lock Cutting Head in the down
position.
Refer to the Engine Manual for complete shut down procedure.
(D)
Open the Cooling Flow Control
Valve and adjust flow. Verify cooling
flow exists on both sides of the blade.
(E)
Move the Throttle Lever to
adjust blade speed (faster blade
speed for smoother cuts) Refer to En-
gine Manual for your specific engine.
(F)
Setup to Cut.