MK Diamond MK-2000 Gas Saws - Manual (Page 22)

22
(C)
Pivot front of Water Pump Drive
End Pivot Plate up and tighten
the retaining bolts.
ALWAYS avoid inhalation of and skin contact with silica dust and/or mist.
(D)
Loosen Water Pump Drive
End Pivot Plate front and rear
retaining bolts.
(B)
Identify Water Pump Drive
End Pivot Plate.
(A)
Move Water Pump Assembly
to the outside of the
Water Basin.
MK-2000 GAS SAW OPERATION
DRY BLADE OPERATION
NOTE: Failure to perform the following steps will lead to premature pump failure.
1. Carbon monoxide gas is toxic. Breathing it can cause unconsciousness
and/or death. Use only in well ventilated areas. DO NOT use indoors.
2. Avoid any areas or actions that expose you to carbon monoxide.
ENGINE START
DANGER
Refer to Engine Manual for proper engine operation of your specific saw.