MK Diamond MK-2000 Gas Saws - Manual (Page 23)

23
DO NOT FORCE TOOL, it will do the job better and safer at the rate for which
it was designed.
Skip steps C and D, if cutting dry.
(B)
Position the masonry piece.
(E)
Setup to Cut.
(D)
Move the Throttle Lever to
adjust blade speed. Refer to Engine
Manual for your specific engine.
(H)
Repeat steps F and G until cut
is complete.
(G)
Step Cut “Pull” stroke. Lower
blade 1/4” - 1/2” inch.
(F)
Step Cut “Push” stroke.
MK-2000 GAS SAW OPERATION
A Step Cut is performed when a series of small cuts of increasing depth are used to complete a single
cut. Step Cuts are used for large objects or for hard objects such as firebrick and pavers.
1. Step Cutting is the preferred cutting method for all cuts.
2. When cutting hard material Step Cutting should always be used.
3. Step Cutting will extend the life of the Diamond Blade.
NOTE:
CAUTION
(A)
Set the adjustable Cutting
Guide.
(C)
Open the Cooling Flow Control
Valve and adjust flow. Verify cooling
flow exists on both sides of the blade.
NOTE:
STEP CUTS
(I)
Move the Throttle Lever to lower
blade speed. Refer to Engine
Manual for your specific engine.