Mk-2000 gas saw assembly – MK Diamond MK-2000 Gas Saws User Manual
Page 16
16
MK-2000 GAS SAW
ASSEMBLY
STAND (Optional)
(A)
Open the stand and place
it on flat surface.
If using the MK Diamond Stand (Part# 153331), follow these steps.
(B)
Set saw on stand as shown.
(C)
Ensure pins are placed
through holes on frame
NOTE:
MOVABLE CUTTING TABLE INSTALLATION
(A)
While holding the front, position
movable Cutting Table roller wheels
above Guide Rails
(B)
Seat movable Cutting Table roller
wheels on saw Guide Rails
(C)
Verify movable Cutting Table is
seated correctly by moving table
back and forth.
See also other documents in the category MK Diamond Power saws:
- MK-770 (41 pages)
- MK-770 EXP (46 pages)
- MK-660 (44 pages)
- MK-470 (12 pages)
- MK-377 (36 pages)
- MK-370 (36 pages)
- MK-370 EXP (52 pages)
- MK-170 (36 pages)
- MK-145 (32 pages)
- MK-145 220 Volt (32 pages)
- MK-101 (52 pages)
- MK-101 (56 pages)
- MK-101-24 (52 pages)
- MK-101-24 (56 pages)
- MK-101 Pro / Pro24 (56 pages)
- MK-101 Tracker (45 pages)
- MK-101Pro24 JCS (60 pages)
- MK-101 JCS Rental (51 pages)
- MK-101 Lowes (56 pages)
- MK-101 Lowes (52 pages)
- MK-100 (44 pages)
- MK-100 (52 pages)
- MK-100 Tracker (46 pages)
- MK-100 JCS (49 pages)
- TX-3 (52 pages)
- Saw Tent (2 pages)
- MK-112 (28 pages)
- MK-1070 (22 pages)
- MK-212 (52 pages)
- MK-1590 (36 pages)
- MKDX Profile Milling Machine (40 pages)
- MK-EZ Profile Milling Machine (36 pages)
- MK-1503SS (24 pages)
- MK-1080 (44 pages)
- MK-1080 (1 page)
- MK-1080 (3 pages)
- MK-1280 Gas Saw (48 pages)
- MK-1280 Electric Saw (40 pages)
- MK-1280 Rolling Cart (4 pages)
- MK-1270 (Shindaiwa) (28 pages)
- MK-2000 Electric Saws (52 pages)
- MK-2000 Gas (60 pages)
- MK-5005S (56 pages)
- MK-5000 Gas Saws (56 pages)
- BX-3 (36 pages)