MK Diamond MK-2000 Gas Saws - Manual (Page 20)

20
Proper Oil Level
Low Level
Upper Limit
the pre-start inspection should be performed before beginning any job. the operator must be aware
of the machines capabilities and limitations. It is the operators responsibility to use this machine un-
der safe working conditions and conform with federal, state and local codes or regulations pertaining
to safety, pollution, noise, etc...
If the Diamond Blade shows signs of fatigue cracking, replace the blade before
starting work.
(C)
Verify movable Cutting Table
moves freely.
(B)
Inspect Wooden Strip for
excessive grooves.
(A)
Inspect Blade for damage –
Verify Blade correct for material
being cut.
(F)
Check for proper oil level.
(See Engine Manual if low)
(E)
Inspect MK-2000 Gas Saw for
general damage, loose connec-
tions and hardware.
(D)
Inspect Engine for leaks.
(H)
Check Air Filter for cleanliness.
(See Engine Manual)
(G)
Check for proper fuel level.
(See Engine Manual if low)
MK-2000 GAS SAW INSPECTION
PRE-START INSPECTION
CAUTION
Fill throat