MK Diamond MK-2000 Gas Saws - Manual (Page 21)

21
this is the preferred method of cooling when using a “wet” diamond blade.
1. Water Pump could interfere with masonry being cut.
2. Water should be periodically replaced when using this method.
MK-2000 GAS SAW SETUP
WATER PUMP SETUP
NOTE:
To extend the life of the Diamond Blade and Water Pump, MK Diamond recommends a
clean cooling water source when using a Wet Diamond Blade.
The Water Pump can be setup in three ways, External Water Source, Re-circulation or Un-coupled for
dry blade operation.
EXTERNAL WATER SOURCE
(B)
Remove Water Pump from
clamp.
(A)
Remove the Drain Plug and
place a catch basin below the
drain hole.
(C)
Place the Water Pump Assem-
bly into a filled Water Container.
RE-CIRCULATION
NOTE:
(A)
Install the Drain Plug and fill
Water Basin.