MK Diamond MK-2000 Gas Saws - Manual (Page 36)

36
Oil is a major factor affecting performance and service life. Use 4-stroke automotive detergent oil.
SAE 10W-30 is recommended for general use. Other viscosity oil shown in the chart below may be
used when the average temperature in your area is within the recommended range.
1. Drain used oil while the engine is warm.
2. Conform to Federal, State and Local laws, codes and ordinances relative to
environmental protection for oil disposal.
-20ºF 0ºF 20ºF 40ºF 60ºF 80ºF
10W -30
5W-30
30
-20ºC -10ºC 0ºC 10ºC 20ºC 30ºC 40ºC -30ºC
MK-2000 GAS SAW MAINTENANCE
CHANGING OIL
NOTES:
NOTE: Refer to Engine Manual for proper engine operation of your specific engine.
Refer to Engine Manual for your specific engine.
ENGINE AIR FILTER INSPECTION CLEANING AND REPLACEMENT
NOTE:
1. Gasoline is highly flammable and explosive. You can be burned or seriously
injured when handling fuel.
2. To fuel, stop engine if running and allow it to cool.
3. Refuel in a well-ventilated area
4. Keep gasoline away from appliance pilot lights, barbecues, electric
appliances, power tools, etc.
5. Wipe up spills immediately.
1. Conform to Federal, State and Local laws for the proper disposal of fuel.
2. Fuel can damage paint and plastic. Be careful not to spill fuel when filling the
fuel tank. Damage caused by spilled fuel IS NOt covered under the warranty.
3. DO NOt use stale or contaminated gasoline or an oil/gasoline mixture.
4. If using a stand with the MK-2000 Gas Saw, an OSHA approved ladder is
recommended when fueling.
5. When installing the Sediment Cup retaining bolt, ensure the threads of the bolt are
aligned with the threads on the Fuel Valve so as not to “cross-thread the nut.”
FUEL SEDIMENT CUP CLEANING
WARNING
NOTES:
Refer to Engine Manual for your specific saw.