MK Diamond MK-2000 Gas Saws - Manual (Page 24)

24
Note: Skip step C, if cutting dry.
(B)
Position the masonry piece.
(A)
Set the adjustable Cutting
Guide.
MK-2000 GAS SAW OPERATION
DO NOT FORCE TOOL, it will do the job better and safer at the rate for which
it was designed.
CAUTION
NOTE:
CHOP CUTTING
A Chop Cut is performed by cutting completely through an object in one pass.
(J)
Raise Cutting Head once
cut is complete and turn OFF saw.
Refer to engine Manual for complete
shutdown procedures.
(C)
Open the Cooling Flow Control
Valve and adjust flow. Verify cooling flow
exists on both sides of the blade.
(D)
Move the Throttle Lever to
adjust blade speed. Refer to
your specific Engine Manual.
(E)
Setup to Cut.
(F)
Lower Cutting Head
to begin the cut.