Welch Allyn Spot Vital Signs LXi - User Manual - Manual (Page 36)

26 Controls, Display Window, and Connections Welch Allyn Spot Vital Signs LXi
SpO
2
Sensor
Spot LXi is available with a wide variety of SpO
2
sensors and ships with a reusable finger
clip sensor. All other sensors are accessory items that are sold separately (see “Pulse
Oximetry” on page 69).
1. Align the shape and pin configuration of the extension cable connector to the SpO
2
cable connection port on the left side of the Spot LXi device.
2. Push the connector firmly into the SpO
2
cable connection port until you hear it click
into place (see Figure 5 on page 23).
3. Align the opposite end of the extension cable to the sensor cable connector and
firmly push them together.
Quick Reference Card
Attach the Quick Reference Card to the Spot LXi handle, mobile stand, or wall mount
using the supplied plastic cable tie.
AC Power Transformer
The operator can use the Spot LXi with AC or battery power (after charging the battery).
1. Insert the round transformer connector into the AC power connection port on the
back of the Spot LXi (see
Figure 5 on page 23).
2. Insert the line cord into the line connector on the transformer then plug the power
cord on the transformer into the AC main power source to charge the battery.
WARNING Use only Masimo or Nellcor SpO
2
sensors and accessories with the
Spot LXi with Masimo or Nellcor configurations, respectively. Using the wrong or
unapproved sensors or cables may cause improper performance.