Welch Allyn VS100 Welch Allyn Vision Screener - User Manual - Manual (Page 23)

P/N 20146 Rev A Page 23
3. If the settings are correct, try turning the vision screener off, then back on.
4. Check on the “Home” screen to see if your network name and IP address is identified in the
upper left corner in the black bar.
NOTE: Restarting helps to reinstate the connection to the network.
5. If the connection does not automatically reconnect, go to Tools, Network, select Security Type,
reselect the correct type (None, WEP, WPA) then select the highlighted “Ok”. This should re-
instate the network connection.
System Messages
Specific system messages may appear while operating the vision screener. If so, the information
below will assist you in identifying what the messages indicate:
Message Text
Message
Actions
Meaning Action
Sorry for the inconvenience.
We need to reboot the
device.
Ok or
Cancel
Screening mode has encountered
a problem and the device needs
to be restarted.
Select Ok and the device will
power cycle itself. If the problem
persists, contact Welch Allyn
Support.
Problem Encountered. The
vision screener needs to
reboot.
Reboot
The system was not able to start
and has attempted to correct the
issue
Select Reboot and try again. If
problem persists, contact Welch
Allyn Support.
The screening system is not
available.
None
The Exam system did not
initialize, or is unresponsive.
Power cycle the device and try
again. If problem persists, contact
Welch Allyn Support.
The screening system is not
initialized.
None
The Exam system did not
initialize, or is unresponsive.
Power cycle the device and try
again. If problem persists, contact
Welch Allyn Support.
The vision screener has not
finished saving the previous
screening.
None
The system has detected that it is
still saving files to disk from a
previous exam.
Power cycle the device and try
again. If problem persists, contact
Welch Allyn Support.
Un-calibrated Device None
The system has not been able to
read the device configuration file.
Power cycle the device. If problem
persists, contact Welch Allyn
Support.
For more information on troubleshooting or error messages, contact Welch Allyn’s support team
(refer to the last page of this manual for additional contact information).