Welch Allyn VS100 Welch Allyn Vision Screener - User Manual - Manual (Page 14)

P/N 20146 Rev A Page 14
3. On the Network screen, select “Ok” to save changes, otherwise changes will not be applied.
To enable or disable the wireless capabilities on the vision screener:
1. Select the “On/Off” button from the network menu.
2. You will be prompted to Disable or Cancel. If you Disable wireless, the device will need to be
rebooted to turn Wireless On. After rebooting, go to Networks and select “On/Off” then
confirm Enable. NOTE: Wireless must be on for printing to be enabled.
To view advanced network settings, select TCP/IP. From here, you can also view your current
TCP/IP address as assigned by your network. For additional network configurations, select “Static”
to manually configure your network address and settings. (Also available is the MAC address of your
vision screener - Figure 12).
Printer Configuration
The vision screener is capable of connecting and printing to most network capable Hewlett-Packard
(
HP) printers. The vision screener also contains some generic PCL drivers that can be used with
non-HP printers, as well as a custom driver that supports the Brother QL-720NW label printer.
NOTE: In order to install the QL-720NW on the vision screener, it must have QL-720 in its name on
the network and you must select the driver labeled QL-720NW from the driver list. Use Brother
DK2205 Continuous Length Paper Tape or equivalent.
1. From the “Tools” menu, select the printer icon.
2. The next screen will list the available printers on the vision screener. This is a list of all printers
already added to the vision screener. (Figure 13).
F i g u r e 1 2