Welch Allyn VS100 Welch Allyn Vision Screener - User Manual - Manual (Page 15)

P/N 20146 Rev A Page 15
To select or change a default printer:
1. From the printer list, find and select the desired printer (it will auto-highlight in blue.) If more
than one printer is listed, touch Set as Default button for the highlighted printer.
To add a printer to your list, press the Add button (Refer to “Adding a Printer” section below).
To configure a printer, select a printer then press the Edit button to view printer Status or print
a test page.
To delete a printer:
1. Select the printer from the available printer list; touch the button to delete.
2. A pop-up will appear asking you to confirm deletion of the printer.
To reset the printer system which will delete all printers:
1. Touch the trashcan icon.
2. A pop-up will appear; select “Delete”. This will remove all current printer configurations.
Adding a Printer
1.
From the “Printers Available” screen, select the plus sign to add a printer. (Figure 13).
2. If any printers are found on the network, they will appear in the list. If your printer is not shown,
select “+ Add New Printer” at the top of the screen (Figure 14) or you can select the printer you
wish to add then the continue icon
NOTE: Make sure you are connected to a wireless network with available printers for the vision
screener to show printers available.
F i g u r e 1 3