Licensing – Welch Allyn VS100 Welch Allyn Vision Screener - User Manual User Manual
Page 21
P/N 20146 Rev A
Page 21
2.
You will be prompted to enter the username and password.
•
Username: spot
•
Password: 0000
NOTE: If you have enabled “Security” on your device, the password will be your four-digit pin
code.
3.
Default will go to the “report” folder. This contains the pdf folder where you can find subject
PDF files.
4.
To view the SpotResults.csv file change to the “db” directory.
Licensing
In order to use the screening functionality of the vision screener, the device needs to be licensed. If
your device came new from the factory with this instruction document, your license is already
installed and active. If you have updated the software on your device, the licensing will need to be
updated as follows:
1.
Connect an empty USB device to the vision screener USB port.
2.
Go to tools, then the Spot License button.
3.
After a moment, a dialog box will appear indicating that the registration file has been exported
to the USB drive.
4.
Send the file titled spot-[serial number].reg to Welch Allyn Support
at
.
Welch Allyn Support will review your registration file and email you back a valid license key. Once
you receive the key, perform the following:
1.
Save the file to the top level (root directory) of a USB Drive.
2.
Insert the USB drive into the USB port on the vision screener.
3.
From the Tools menu, select Spot License.
4.
After a moment, a dialog box will appear indicating that the license file has been imported onto
the device.