Crestron electronic Multimedia Presentation System 300 MPS-300 - Manual (Page 83)

Crestron MPS-300 Multimedia Presentation System 300
Turn On the System To turn on the system:
1. Press the soft button labeled Source to display a list of available sources.
2. Turn the Nav Wheel to highlight the desired source (BNC 1, BNC 2,
RGBHV 3, RGBHV 4, RGBHV 5, QM IN 6, QM IN 7, or QM IN 8).
NOTE: Typically, signal routing information is not displayed on the front
panel of the MPS-300. However, if an output button on the MPS-300 was
pressed at any point during operation, routing information will be displayed
and updated should any changes to routing be made.
3. Press the soft button labeled Select to route the source to the projector and
touchpanel output.
Turn Off the System To turn off the system:
1. Press the Power button.
2. Press the soft button labeled Sys. Off.
3. Press the soft button labeled Yes to confirm. The display will indicate that
the system is turning off.
Raise or Lower the Projection
Screen To raise or lower the projection screen:
1. Press the soft button labeled Environ.
2. Press the soft button labeled Screen.
3. To raise the projection screen, press the soft button labeled Up. To lower
the projection screen, press the soft button labeled Down. The display will
indicate the status of the projection screen. The front panel of the MPS-300
will indicate the screen’s status.
NOTE: This function will only work if a projection screen’s control lines have been
connected to RELAY 1 (up control) and RELAY 2 (down control).
Adjust the Volume Level The volume level of the MPS-300 is adjusted with the Nav wheel.
The volume controlled by the APAD is determined by the volume control mode
setting. If the volume control mode was set to MASTER VOLUME, then the
APAD will control the master volume. Otherwise, the APAD will control the
program volume only. For more information on the volume control mode, refer to
page 46.
• Raise the volume: Turn the Nav wheel clockwise. The volume level will
be displayed on the LCD.
• Lower the volume: Turn the Nav wheel counterclockwise. The volume
level will be displayed on the LCD.
Operations Guide – DOC. 6529B Multimedia Presentation System 300: MPS-300
• 79