Crestron electronic Multimedia Presentation System 300 MPS-300 - Manual (Page 54)

Multimedia Presentation System 300 Crestron MPS-300
NOTE: While adjusting the Speech Startup Volume level, the Speech
Volume level can be adjusted by turning the volume control clockwise to
raise the volume, or counterclockwise to lower the volume. When adjusting
the volume, the display will change to indicate the volume level.
• Press MENU or ENTER to save changes and return to the previous screen.
Record Output
The Record Output section of the Audio Setup menu is used to set the RECORD
output’s volume level, source mix, output mode, and startup volume. The
PROGRAM and SPEECH outputs are not affected by changes made to the Record
Output controls.
Access the Record Output
Menu To access the Record Output menu:
• Access the Audio Setup menu as described on page 38. The words “Audio
Setup” will be displayed.
• Press the k or j buttons until “Record Output” is displayed on the LCD
and press ENTER to open the Record Output menu.
• To return to the Audio Setup menu, press MENU.
Set the Record Volume Level To set the Record Volume level:
• Access the Record Output menu as described above.
• Adjust the Record Volume level by turning the volume control clockwise to
raise the volume, or counterclockwise to lower the volume. When adjusting
the Record Volume level, the display will change to indicate the volume
level.
NOTE: The Record Volume can only be used if the Fixed/Variable Mode
is set to “Variable”. For more information, refer to “Set Fixed/Variable
Mode” on page 51.
Set the Record Source Mix To set the RECORD output’s source mix:
• Access the Record Output menu as described above.
• Press ENTER to open the Record Source Mix controls.
Record Source Mix Controls
Record Source Mix
Aud. Only
50
• Multimedia Presentation System 300: MPS-300
Operations Guide – DOC. 6529B