Crestron electronic Multimedia Presentation System 300 MPS-300 - Manual (Page 46)

Multimedia Presentation System 300 Crestron MPS-300
• Adjust the Program Maximum Volume level with the j and k buttons.
Press the k button to increase the Program Maximum Volume level. Press
the j button to lower the Program Maximum Volume level. The lowest
Program Maximum Volume setting is 50%.
NOTE: While adjusting the Program Maximum Volume level, the
Program Volume level can be adjusted by turning the volume control
clockwise to raise the volume, or counterclockwise to lower the volume.
When adjusting the volume, the display will change to indicate the volume
level.
• Press MENU or ENTER to save changes and return to the previous screen.
Set the Stereo / Mono Mode The Stereo / Mono controls are used to set the PROGRAM output mode. The audio
sent to the speaker outputs can be set for either stereo or mono. When set to stereo,
the audio signal is separated into left and right channels for distribution to left and
right speakers or amplifier channels. When set to mono, the audio signal is combined
into one signal and sent to both channels for use in larger rooms where stereo
separation is not practical. The RECORD and SPEECH outputs are not affected by
changes to the stereo/mono mode.
To set the Stereo / Mono mode:
• Access the Program Output menu as described on page 38.
• Press the k or j buttons until “Stereo/Mono” is displayed on the LCD and
press ENTER to open the Stereo / Mono controls as shown in the following
diagram.
Stereo / Mono Control
Select Stereo/Mono
*Stereo
• Press the k or j buttons until the desired mode is displayed on the LCD
and press ENTER. The current setting is indicated with an asterisk (*).
NOTE: While adjusting the Stereo/Mono setting, the Program Volume
level can be adjusted by turning the volume control clockwise to raise the
volume, or counterclockwise to lower the volume. When adjusting the
volume, the display will change to indicate the volume level.
• Press ENTER to save changes and return to the Program Output menu. To
cancel without saving changes, press MENU.
Adjust the Program Startup
Volume The Program Startup Volume control is used to establish the PROGRAM output’s
volume level setting when an input is selected. The RECORD and SPEECH
outputs are not affected by changes made to the Program Startup Volume level.
42
• Multimedia Presentation System 300: MPS-300
Operations Guide – DOC. 6529B