Crestron electronic Multimedia Presentation System 300 MPS-300 - Manual (Page 43)

Crestron MPS-300 Multimedia Presentation System 300
Set the Program Source Mix To set the PROGRAM output’s source mix:
• Access the Program Output menu as described in “Access the Program
Output Menu” on page 38.
• Press the k or j buttons until “Source Mix” is displayed on the LCD and
press ENTER to open the Program Source Mix controls.
Program Source Mix Controls
Program Source Mix
Aud. Only
• Press the k or j buttons until the desired setting is displayed on the LCD.
The current setting is indicated with an asterisk (*). The following settings
are available:
⇒ Aud. Only: Sends the audio signal from the selected source to the
PROGRAM output.
⇒ Mic. Only: Sends the microphone input signals to the PROGRAM
output.
⇒ Mic + Aud: Sends a mix of the audio signal from the selected source
and the microphone input signals to the PROGRAM output.
NOTE: While setting the program source mix, the Program Volume
level can be adjusted by turning the volume control clockwise to raise
the volume, or counterclockwise to lower the volume. When adjusting
the volume, the display will change to indicate the volume level.
• Press ENTER to save changes and return to the previous screen. To cancel
without saving changes, press MENU.
Set the Program Bass Level To set the Program Bass level:
• Access the Program Output menu as described on page 38.
• Press the k or j buttons until “Bass” is displayed on the LCD and press
ENTER to open the Program Bass controls. The current bass level will be
displayed.
Operations Guide – DOC. 6529B Multimedia Presentation System 300: MPS-300
• 39