Rice Lake TradeRoute HL Series - Installation and Service Manual (Legal-for-Trade) - Manual (Page 49)

Repair Parts 45
Legal for Trade Inspection
The exact inspection procedures may vary slightly in your region from those described below. The following is the
basic inspection procedure:
1. Balance test (as described in Section 3.3).
2. Increasing/Decreasing load test.
3. Out of level increasing/decreasing load test.
4. Twist condition increasing/decreasing load test.
5. Out of level shut off test.
6. Printing of ticket.
Final Installation Checklist
Ensure a good consistent +12V DC power source.

Check proper operation of the hardware alarm.

Level Switch check. Turn on the indicator and move the truck onto a slope larger than 6
degrees. The indicator will show OFF LEVEL. Do this in all four directions – front high, front
low, left high and left low.

Check to ensure the scale swings freely at all angles (does not contact anything off the
scale)

After calibration is completed, check the lockdown adjustment (see Section 2.7).

Check all hoses, wiring and any other components to ensure they do not interfere with the
operation of the scale.

Ensure all mounting bolts are tight.

Check that fenders are mounted to the truck frame (not the scale).

Make certain all personnel using the scale have a full understanding of the operation and
any safety precautions.

__________________________________________________________
Name Date