Rice Lake TradeRoute HL Series - Installation and Service Manual (Legal-for-Trade) - Manual (Page 20)

16 Trade Route Installation Manual
2.8 Electronic Weigh Center Mounting
A suitable location must be found for the electronic weigh center. Rice Lake Weighing Systems recommends
mounting the electronic weigh center near the front driver’s side corner of the container. However, the location for
the electronic weigh center is application specific and is dependent on the end user’s needs.
Important
The electronic weigh center must be mounted level with the scale. The weigh center contains a level
switch that detects the degree to which the scale is off level. Therefore, the weigh center must be
mounted level with respect to the scale.
2.8.1 920i
®
Electronic Weigh Center
12.54"
(319 mm)
Side View
Door Open
6.65"
(169 mm)
Side View
24.37"
(619 mm)
14.16"
(360 mm)
12.50"
( 317 mm)
Front View
17.00"
(432 mm)
4.50"
(114 mm)
8.11"
(206 mm)
Bottom View
Red LED
Weigh Center
Weight = 45 lbs
Figure 2-15. Electronic Weigh Center Dimensions
The electronic weigh center comes standard with vibration mounts to protect the indicator. A bracket (plate with
holes) is required. Ensure the bracket is attached level with the scale (see above).
Important
Note
Electronic weigh center mounting brackets are available from Rice Lake Weighing Systems with drawings
provided that are suitable for manufacturer.
The red LED on the sides of the weigh center must be viewable through the driver’s rear view mirror to
alert the driver when the system is in the weighing mode.