Rice Lake TradeRoute HL Series - Installation and Service Manual (Legal-for-Trade) - Manual (Page 24)

20 Trade Route Installation Manual
2.11 Cell Covers
The final step in the mechanical installation is attachment of the load cell covers. Bolt the covers in position as
shown in Figure 2-19 with ¼ " bolts and lock washers.
Load Cell Cover
Bolt and
Lock Washer
Figure 2-20. Load Cell Cover
2.12 Load Cell Numbering
Systems balanced at the factory
Systems that are balanced at the factory have load cell numbers already assigned. Connect numbered load cell
wires to the corresponding connector on the circuit board.
Systems balanced at installation
Systems that have not been balanced at the factory, but are to be balanced at installation, should follow the load cell
number convention shown below.
Cell #2
Cell #1
Cell #3
Figure 2-21. Load Cell Numbering for Three-Point System