Rice Lake TradeRoute HL Series - Installation and Service Manual (Legal-for-Trade) - Manual (Page 22)

18 Trade Route Installation Manual
2.10 Conduit Connections
Follow for assembly of conduit connectors.
Two-piece nylon swivel body enables
fitting to twist from 0 to 90°
Non-integral ferrule provides conduit seal
and superior pullout protection
Nylon compression nut
has a tapered dome to
tighten ferrule onto
conduit
Neoprene o-ring provides
liquid tight seal at hub or enclosure
Nylon locknut fastens connector
securely to enclosure and provides
superior corrosion resistance
Note
Rice Lake Weighing Systems supplies 80 feet of conduit cable with each system. Additional cable can be
purchased at time of order.
Figure 2-18. Non-Metallic Conduit Connectors
All load cell cables are run in the flexible conduit.
The power wire and reed switch (hardware alarm) should be covered with conduit to keep weigh center watertight.
2.10.1 Conduit Termination
To keep moisture and unwanted pests and debris from the cable, install a silicon sealant over the cable that is run
inside the conduit.