Rice Lake TicketPress - Installation and Operation Manual - Manual (Page 11)

Menu Settings Print Button Actions
Normal Operation

(Fault Indicator is Off)
Print Mode = Standard
Data Mode = N/A Interface Pin 11 Pulsed.
Print Mode = Weight Extraction
Data Mode = Continuous (Streaming) Interface Pin 11 Pulsed.
Print Mode = Weight Extraction
Data Mode = Demand Print next valid indicator record.
Fault Condition

(Fault Indicator is On)
N/A Printer will only attempt to clear the fault and continue
printing.
Daily Operation 7
Table 3-3. Print Button Actions
3.2 Check Ticket Fault
If the TicketPress receives data to print and no ticket has been inserted, the printer will sound a long beep and
Ticket Out will display.
To clear the fault:
1. Make sure a ticket has been inserted, is aligned with the ticket edge guide, and inserted far enough to be
aligned with the print line indicator.
2. When the ticket is inserted properly, the printer will automatically continue printing.
Note
The ticket sensor may be disabled as described in the “Options Menu” on page 9. This is not
recommended for normal use as printing without a ticket installed causes additional wear on the
print head and causes ink to be deposited on the platen surface.
For a complete list of all fault messages and instructions for clearing the fault, refer to “Fault Messages” on
page 30.