Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 9)

6 SST3 Installation Manual
10. Place the O-ring over the cable end and into the groove around the split seal plates (Figure 1-8, right
image). This will hold the plates together and also offer a watertight barrier.
11. Connect the communications plug to the appropriate connection on the back of the printer.
Figure 1-9. Connect the Communications Cable to the Back of the Printer
12. Carefully push the whole split seal assembly down into the printer enclosure as shown below.
Figure 1-10. Seat the Split Seal Assembly
13. Wrap a split grommet around the cable with the small end of the grommet pointing downwards. Orient
the grommet split to a position that is 90 degrees to the split in the split seal insert and press the grommet
into the tapered hole in the split seal insert. At this time, position the cable to make a 90 degree bend
from the printer.
Figure 1-11. Insert Split Grommet Onto the Split Seal Plates