Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 8)

Introduction 5
Note: Ensure that the split communications cable main plate is oriented so that the tapered side is facing up
as shown in Figure 1-6. An easy way to tell if the main plate is oriented correctly is to note that the four holes
on the main plate have counter bores which should face down. Refer to Figure 1-6.
.
Figure 1-6. Incorrect and Correct Orientation of Main Plate
7. Pass the communications cable through the printer base and main plate. Make sure that the cable end and
printer communications socket match correctly.
Figure 1-7. Communications Cable Comes Up Through Bottom of Hole
8. Push the entire SST3 enclosure unit back onto the table or other sturdy work surface.
9. Assemble the split seal plates back together with the cable in between (Figure 1-8, left image).
Note: Run finger across the split seal plates to ensure there is no dirt or oil on the surface prior to joining the two
surfaces together.
Note: Make sure the larger diameter hole side is facing upwards as you put the two pieces together.
Figure 1-8. Assemble The Split Seal Plates Together
E n s u r e t h a t
the larger side
of the tapered
p o c k e t i s
f a c i n g
upwards when
pl ac ing it on
the four studs
Note counter
bore