Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 16)

Introduction 13
1.1.4 Label Peel and Present
Use the following steps to load label peel and present. With this option, labels printed in a batch will
automatically be separated from the backing material and dispensed on demand which means printing will occur
only after a previously printed label has been removed from the printer.
1. Make sure printer is sitting on a horizontal surface.
2. Open printer cover by unlocking the hinged latches that are located on both sides of the unit and lifting
the cover to the front of the unit.
3. Press in the latch to open the mechanism as shown in Figure 1-25.
Figure 1-25. Opening Latch for Peel and Present
4. Swing the mechanism open as shown in Figure 1-25.
5. Load the printer with media.
Figure 1-26. Load Printer With Media
6. Load the media into the printer as you normally would for tear-off operation, however, extend an
additional 12 inches (30 cm) of media out the front of the printer.
7. From this above 12 inches of media, remove all of the labels, so that only the backing material remains.
Press latch mechanism
to open
.