Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 27)

24 SST3 Installation Manual
4.2.1 Setting up the Baud Rate
Use the following steps to set up the baud rate on the printer.
1. Push the Menu key to access the communications menu.
2. Use the Up and Down keys to access the baud rate, parity, data bits and stop bits. The default settings are
9600, 8, and none.
3. Save and exit out of the menu.
4.3 USB
The USB connection supports Windows 95 and greater operating systems with a USB connection.
Optional - Ethernet print servers (wired and wireless) are available.
4.4 Communicating to RLWS Indicators
To communicate from a RLWS indicator directly to the SST3, a change to the standard RS-232 output is
required. The indicator must have Smart Serial communication or a custom serial format developed.
Minimum cable requirements are ground plus TX with the ground going to pin 5 on the printer and TX going to
pin 2 on the printer.
4.5 Printer Operation
The SST3 uses a Datamax M-Series Mark II printer. Complete operation information is enclosed on the CD that
accompanies this product. Specific information relating to operation, main menu structure, setting up parameters
are contained in the CD
.