Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 18)

Introduction 15
1.1.5 Auto Sense Setup
The present sensor is automatically set up when installed. If necessary to set up at a later time, use the following
steps to set up the auto sense.
1. Access the menu through the front panel of the printer.
Figure 1-30. SST3 Main Display
2. Press through the menu on the front panel until you get to Printer Options.
3. Press the down or up key to access Present Sensor.
4. Enable the sensor.
5. Press the Enter key to save and exit.
Time and Date
Main Display Area
Soft Keys
Menu, Test and Navigation Buttons
Soft Key Labels
Printer Status Line
Current State Icons
Fault
Paused/Stopped
Receiving Data