Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 46)

Options 43
17. Press the assembly down and partially tighten the four nuts that hold the entire assembly in place. Once
all the nuts are started, tighten the nuts in a diagonal sequence until all the nuts are tight using a 7/16”
socket and torque wrench. Tighten to 30 in/lb torque.
Figure 5-38. Tighten Up The Entire Assembly
When tightening plates make certain to allow enough slack in cable. See Figure 5-39.
Figure 5-39. Keep Proper Amount of Slack in Cable
18. Close and latch printer cover.
19. Turn printer case on side to expose four mounting screws on bottom.
20. Tighten four screws with Phillips Screwdriver.
Figure 5-40. Tighten Four Mounting Screws
Make certain slack is
present as shown in
p i c t u r e t o a l l o w
se aling of cable to
print case
F o u r
m o u n t i n g
screws