Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 7)

4 SST3 Installation Manual
2. Pull the SST3 enclosure forward so that it hangs slightly off of table edge to allow access to the bottom
access hole.
3. Remove split communications cable plates by pushing with fingers up through the bottom access hole
from the underside to dislodge the split communications cable plates. Set aside.
Figure 1-3. Remove the Component Parts of the Split Communications Cable Assembly
4. The split communications cable plate is made up of several individual pieces that are shown in Figure
1-4.
Figure 1-4. Component Pieces
5. Ensure the rubber gasket is seated properly in the SST3 printer enclosure.
Figure 1-5. Rubber Gasket
6. Set the main plate over the four studs with recesses around the four holes located downward and press
down.
Clamp plate
Half clamp
plate
S p l i t
communications
cable main plate
O-ring
Split seal
plates
S e a l
plug
L a r g e &
small split
s e a l
gromment
Rubber gasket