Rice Lake SURVIVOR SST3 Washdown Printer - Manual (Page 11)

8 SST3 Installation Manual
1.1.3 Loading Labels into the Printer
Use the following steps to load labels into the printer.
1. Make sure printer is sitting on a horizontal surface.
2. Open printer cover by unlocking the hinged latches that are located on both sides of the unit and lifting
the cover to the front of the unit.
Figure 1-15. Hinged Latch Location
3. Open the media cover and lower the media hanger guide (if equipped) and media guide
4. Press in on the printhead latch and raise the printhead assembly.
Figure 1-16. Printhead Loading Sequence
5. Slide the roll media onto the media hub or media hanger. If the printer is equipped with a media hanger,
raise the media hanger guide. The media hanger guide should be pushed inward so that it is just touching
the roll media.
O p e n t h e
h i n g e d
latches
1. Printhead Latch
2. Media Guide
3. Media Hanger Guide