Rice Lake IQ 700 Configurable Weight Indicator - Manual (Page 60)

56 IQ 700 Installation Manual
Mode E One setpoint with preact, dribble control, and tolerance band output
Converts setpoint two (SP2) to be a tolerance output when WT > SP1 – Lo, but < SP1 + HI.
Use the following steps to set Mode E setpoint values
1. Enter value for SETPOINT 1 .
2. Press SETPOINT 2
3. Enter desired setpoint value, (display times out if no number is entered for several
seconds).
4. Press ENT key. Display flashes number value alternated with
HI
.
5. Enter the desired high tolerance value; then press ENT key.
6. Repeat steps for the low tolerance value (Lo) (Low tolerance = SP1 – Lo).
SP1-Pr
SP1-Pr-dr
TOL
ZBD
Mode F High-Low alarm control
Outputs with low level on when WT < SP1. High level on when WT > SP2.
Use the following steps to set Mode F setpoint values.
1. Press SETPOINT 1 .
2. Enter the desired low level value, (display times out if no number is entered for several
seconds).
3. Press ENT key
4. Press SETPOINT 2 .
5. Enter the desired high level value, (display times out if no number is entered for several
seconds).
6. Press ENT key, display returns to normal operation.
7. The setpoint value can be recalled any time by pressing the appropriate setpoint key.
LOW
ACCEPT
HIGH
ZBD
Mode Description Setpoint
SP1-Pr
-dr
SP1-HI
MODE E
WIRE
PLACEMENT
TB3 - 5
TB3 - 4
TB3 - 3
TB3 - 2 SP1-Lo SP1-Pr
100 90 80 70 60 50 40 30 20 10 0
WEIGHT
ZBD
MODE F
WIRE
PLACEMENT
TB3 - 5
TB3 - 4
TB3 - 3
TB3 - 2
100 90 80 70 60 50 40 30 20 10 0
WEIGHT
ZBD
LOW ACCEPT HIGH