Rice Lake Digital/Diagnostic - iQube - Manual (Page 50)

Appendix 47
Virtui _____________
4. What communication method is being used?
RS-232___________
RS-485___________
Fiber–optic_________
R/F______________
5. What is the iQUBE configuration?
6. Do you have the manual for all the equipment in use?
7. After connection, is there Voltage at the iQUBE ?
8. Is D1 On or Off on the connector board?
9. If using a 920i , continue to step 10.
If using Revolution III , access cell monitoring Via the interactive tab and proceed to step 18
If using Virtui , access cell monitoring and proceed to step 18
10. What is the distance from the 920i to the scale?
11. What port is the iQUBE on?
If using port 3, ensure printer ports are not still set to the default port 3.
12. With the communications on, using TESTCOM , are D5 and D6 or D7 and D8 flashing?
13. If using iRev , is the CONFIG already set up and ready to download?
14. Set up the diagnostic key.
15. Does the download complete to the 920i without error?
16. Did the 920i send the data to the iQUBE ?
17. Does the Cal-Match work?
18. When the scale is empty, are all the current readings near the captured zero?
If yes, go to step 19.
If no, go to step 20.
19. With weight on the scale, do all of the current readings rise to the same degree?
If yes, go to step 20.
If no, go to step 21.