Rice Lake Digital/Diagnostic - iQube - Manual (Page 42)

Alerts 39
7.2 Alert Format
The default 920i alert print format is as follows:
Commands used in the 920i alert format are listed
in Table 7-1.
Values for the contact information referenced by the
print formatting commands shown in Table 7-1 can be
s e t u s i n g t h e
9 2 0 i m e n u s ( F E AT U R E m e n u ,
C O N TA C T s u b m e n u ) , s e r i a l c o m m a n d s ( s e e
Section 8.0 on page 42),or the
iRev configuration
utility.
See the 920i Installation Manual, PN 67887, for more
information about print formatting.
Command Content
Company name (up to 30 characters)
Contact company address, lines 1–3 (up to
30 characters)
Contact names (up to 20 characters)
Contact phone numbers (up to 20 characters)
Contact e-mail address (up to 30 characters)
Alert error message (system-generated)
nn> New line (nn = number of termination (LF> or ) characters). If nn is not
specified, 1 is assumed. Value must be in the
range 1–99.
Table 7-1. Alert Format Commands