Rice Lake Digital/Diagnostic - iQube - Manual (Page 27)

24 iQUBE Installation Manual
SOURCE OFF
system_name Analog output source. If analog output DAC is installed, assign system name.
FULLSC 300000.0
value (weight) Analog output full scale range. Specifies the weight value at the full scale analog output
(30 mV or 20 mA).
BIT 1 – BIT 8 — Specifies the function of the digital I/O bit. See the 920i Installation Manual, PN 67887,
for more information.
ZEROREF ENABLE
THRH
%THRH
DELAY Zero reference diagnostic subparameters. See Table 3-2 on page 26. The zero reference
test compares the millivolt output of section pairs when half of the load cell outputs are
below the specified threshold value.
CELLBAL ENABLE
THRH
%TOLR
LOAD Cell balance tolerance diagnostic subparameters. See Table 3-2 on page 26. The cell
balance test checks the outputs of section pairs for equal load distribution.
LDRIFT ENABLE
LIMIT
%LIMIT
TIME
LOAD Load cell drift diagnostic subparameters. See Table 3-2 on page 26.
PKtoPK ENABLE
LIMIT Peak-to-peak diagnostic subparameters. See Table 3-2 on page 26.
CELLEMU ENABLE
TYPE Cell emulation. See Table 3-2 on page 26 for more information.
MOTBAND 10.00000
value (weight) Motion band. See Table 3-2 on page 26 for more information.
SERIAL Menu ( iQUBE Submenu)
Parameter Choices Description
Table 3-1. Serial Menu Parameters, iQUBE Submenu (Continued)