Rice Lake Digital/Diagnostic - iQube - Manual (Page 31)

28 iQUBE Installation Manual
3.4.3 PFORMT Menu
See the 920i Installation Manual, PN 67887, for general information about print formats. See Section 7.2 on
page 39 for information about the ALERT print format.
NOTE: Port 3 is the default port for most print formats. If the iQUBE is attached to the 920i using port 3, ensure that the serial
print format is not also routed to port 3. Use the PORT parameter to change the print format serial port assignment.
Figure 3-4. PFORMT Menu
SCALES SERIAL FEATURE PFORMT SETPTS DIG I/O ALGOUT VERS
GFMT NFMT ACCFMT SPFMT TRWIN TRWOUT TRFMT
Same as GFMT
PORT 4
PORT 1
PORT 3
PORT 2
PORT FMT
format
HDRFMT1 HDRFMT2 AUXFMT
format format
ALERT
Same as GFMT
NOTE: Default port for
ALERT format is PORT 1
AUDITFMT
Same as GFMT