Rice Lake Digital/Diagnostic - iQube - Manual (Page 47)

44 iQUBE Installation Manual
Command Description
DON.b#s Set digital output on (active) at bit b (9–24), for iQUBE connected to slot s. NOTE: Odd numbered ports
use bits 9–16; even numbered ports use bits 17–24.
Example: To turn on digital output bit 1 for an iQUBE attached to port 3 (slot 0), use DON.9#0.
DOFF.b#s Set digital output off (inactive) at bit b (9–24), for iQUBE connected to slot s. NOTE: Odd numbered ports
use bits 9–16; even numbered ports use bits 17–24.
Example: To turn off digital output bit 6 for an
iQUBE attached to port 8 (slot2), use DOFF.22#2.
SJ.DIO.ALIAS.b#n Digital I/O alias
SJ.DIO.b#n Digital input function. See the 920i Installation Manual, PN 67887, for more information
For SJ.DIO commands, digital inputs are specified by bit number (b, 1–8) and the number of the 920i serial port to which the
iQUBE is attached (n).
Table 8-6. DIG I/O Serial Commands
Command Description Values
SJ.ALG.SOURCE#n Analog output source OFF, system_name
SJ.ALG.FULLSC#n Analog output full scale 0.000001–9999999.0
For commands ending with “#n”, n is the number of the 920i serial port to which the iQUBE is attached
Table 8-7. ALGOUT Serial Commands (Valid Only If Analog Output Option Is Installed)
Command Description Values
CONTACT.COMPANY Contact company name company_name (up to 30 characters)
CONTACT.ADDR1
CONTACT.ADDR2
CONTACT.ADDR3 Contact company address company_address (up to 30 characters for each line)
CONTACT.NAME1
CONTACT.NAME2
CONTACT.NAME3 Contact names contact_names (up to 20 characters each)
CONTACT.PHONE1
CONTACT.PHONE2
CONTACT.PHONE3 Contact phone numbers contact_phone_numbers (up to 20 characters each)
CONTACT.EMAIL Contact e-mail address contact_e-mail_address (up to 30 characters)
See Section 7.0 on page 38 for information about e-mail
notification of
iQUBE alert messages.
CONTACT.NEXTCAL Next calibration date calibration_date
Table 8-8. Contact Serial Commands
Command Description Values
ALERT.FMT Alert format See Section 7.2 on page 39 for information about specifying
the alert format.
ALERT.SERV Alert SMTP server address 0.0.0.0, SMTP_server_IP_address
ALERT.PRN Alert printer port PORTn
Table 8-9. Alert Serial Commands